electrical

OK so my bike engine stalles out while riding from idel to accelerate but is random sometimes its fine? ( short burst stalls) Its 1 of these problems? Fuel system/carb I cleaned out my fuel tank and lines and carb already still stalls I have this carb with a #75 jet on it (it came with a #72 I...

Starting with the headlight- here's the donor system Bought at Wally World for less than $10. 10 LEDs- does a good job of lighting up the road.

New to the forum. 3 builds under my belt so far. The age old question that I can NEVER sort out: How to get proper lighting on a bike? I'd rather skip buying endless amounts of batteries and buying lights that fail after a week or two. I HAVE found a 12v generator that installs next to the...

I have replaced every electrical component on my 66cc 2 stroke and still VERY weak/no spark. New coil, 2 new CDI, new magnet, new spark, everything. Any pro tips are appreciated.

Hi everybody : I am new here and I need your help. 1) I have a 2 Stroke 80cc bike and I would like to know the steps to connect the switch with the coil and the coil with the engine. From the hand switch (Killing Switch ) there are two wires coming out One black and the...

If anyone can help me with this id be very happy because i really miss riding my gasbike. A while back my bike stopped running for no apparent reason, and after much troubleshooting, and replacing every last electrical part on the bike, it still wont run. -_- it gets full compression, and the...

Hello. I ordered a kit off kings motor bikes and they sent me 2 spark plugs. I just ordered a new cdi and a high performance plug wire and boot. Well the plugs that were sent with the kit are not the best. I cant seem to find a cross reference. Since im upgrading electrical i would like a new...

Hello all! Was riding my bike the other day and it died slowly. After a bit of figuring I replaced the CDI ( used). It worked! Then about two weeks later and 150 kms of riding it died again very similar to how it did before. I did not notice going over bumps or anything when it died and the...

Here is my dillema so PLEASE someone help!!!!! I have the same set up like the JN Motors HP Limiter; Don't know where to put which wire. Most of the sites I have been to say it has green, yellow, etc. colored wires. Mine does not as can be seen in the photo. Please tell me where to connect...

Hi all. I bought an Indian Head fender tip light (12V) and a single, bobber style tail light for my cruiser. I have a large 12V battery and a small doo-dad 3 way switch. When I wire up the connections, the Indian head lamp will light, but the tail light will not (even without the switch...