have loads of old bikes

[syke bike]

Hi all. Here in Florida, I've built a couple of moto bikes, one with a B/S 3.5 hp vertical shaft, friction
drive, offset to the side, a little top heavy, but that baby would go, just in idle speed. The other one
was a Tecumseh 1.5 hp horizontal, with a skate board wheel as the friction wheel, until I slung
a bearing. I've also built a grinder, and a built sander out of two other old bikes, I'm in the process
of building a band saw out of parts of an exercise bike. I've seen some engine bikes on the road, but
not up close. I here some of them have problems, like spoke damage, engine mount problems, etc
I would like to buy one of the cheep one's, and see if I can improve on it. Well thanks to all who
reply. Matt

[Finfan]

This forum has a lot of inventors/mad scientists. We are always happy to see new ideas being put forth.

[syke bike]

see I told you so

[deacon]

Welcome the range of builder run from kit builds, diy, and even some ebike builders. You will find something here to strike your fancy. Good luck