Who is the fastest china rider still standing

[Goat Herder]

......................

[Finfan]

That would probably involve a trail that runs to the edge of a cliff. Preferably with deep water at the bottom!

[MikeBike]

im 5'5" and 130, im thinking about going 60, and thanks for welcoming me

[MikeBike]

i know i was messin with you, but going fast is not a problem with me, im useto rideing my uncles drag bike 100+ and his street bike 75( ) but a bicycle whould be much. but take it in stride, your probly way better at this(thats not a joke).

[Andyinchville1]

Hmmmm.....sounds like an interesting goal....FWIW we can make sprockets as small as 18T for use with a disc hub mount.....Should make for some serious speed runs (slightly down hill will no doubt help)....

Andrew

[old motorbike]

Fastest I could get mine with the 44 tooth was 28.2 on GPS It's all stock and untuned. I'm doing shift kit now and then will maybe start tuning. I was just hoping for 45... but 60?

I went stock on my Hayabusa to 187. After modding the engine it went 200.1 gps. I know I'll probably get speed hooked on this also.

[Bikeguy Joe]

You can go fast one one of these, just not for very long. Have fun, be safe.

[MikeBike]

ya, i dont think ill do this on a bike.
i dont think a china girl engine would even do 60mph.
but what about a pockit/pit bike engine, that might need less moding for the speed.
and put on a low-rider like in the motorbicycling.com banner up on top.

faster then 40 you would want to get as low and long as possible, Lessing your chance of wiping out. (aka hurt or dieing!! )

i think ill set my goal for 35-40mph, that shouldn’t be to bad, i dont have to be the fastest, but the funniest...well see

[Bikeguy Joe]

35-40 is easily obtainable with a little "work".

[Smoothe]

How about this: A Franco Morini Engine, Nuvinci Hub setup, and Tuned Pipes on a full-fairing recumbent velomobile? That would hit some speed dont ya think?

But seriously... a shifter kit with a NuVinci setup would be pretty quick.