Does anyone know the 4 hole pattern of the hf auger? I bought one last week
and it appears to be 7.5 centimeters hole center to hole center, the kits I've found
seem to want a 70.7mm four-hole engine mounting bolt pattern plus a 76mm
clutch rotor have not taken the transmission off because i would not know how to measure the clutch incase its an odd ball and wont fit the kits.......Thank you
P.S BMP recommends this engine as compatible but they are not taking orders.
I am building a 2 stroke landmark but this is for a 24 huffy cranbrook
I don't know offhand the dimensions, but I can tell you that I have three of the HF auger engines, one HF water pump engine (same thing, but in blue) in addition to a Honda GX31, a Robin/Subaru EH035 and a Tanaka PF-4000, and they all mount up to the BMP and DAX friction drive kits with no problems.
So, if you know the mounting pattern of any of the above engines, then it is the same for all the others mentioned.
I took the handle with the squeeze throttle, kill switch etc and the gear drive off the auger and I was wondering what do with the red and black wires now that they are unplugged? I am assuming the kill switch on the throttle from dax will wire up but does it need both wires if not what to do ...Thanks
Thanks but is there any color on the kill switch to match the red and black of the auger
engine? is there anything else I do to the red and black wire like ground it to frame or anything or do I just connect both to kill switch wires ?Thanks rohmell