theyre nice, but out of balance and pressed together off center instead of welded.
and im just about done testing and tuning my own adaptation of the stock peice.
the small gear is trued and welded (without disturbing the heat treatment of the teeth of course) to the clutch bell.
the bell is also fully welded.
the clutch is tuned for a later engagement (or stock if you prefer).
will ship within 1 week
$80 to your door
i wasnt planning on offering this for sale yet so i have no pics until sunday.
i dont have a pullstart on this motor, i start it by holding the rear tire off the ground and kicking it over. the one way sprag has never had a failure that way.
8hp test bike