EZM Q Matic

GoldenMotor.com

cigron

New Member
Nov 18, 2009
59
0
0
wormleysburg pa
EZM Qmatic transmission
I was told that I should put a few drops of oil on the
Clutch bushing. I would like to know if someone would
Be kind enough to put up a photo .I would not want to
Put it in the wrong place. And mess up perfectly good clutch.
When I learn how to put up photos ill try to be more help
Then I am now. I learned I lot of this site I would like to contribute
To it maybe be of some help to someone.
 

MotorBicycleRacing

Well-Known Member
Jul 28, 2010
5,844
109
63
SoCal Baby!!!
www.facebook.com
Put a few drops of 30 weight oil on the 5/8" shaft behind the 10 tooth
sprocket and inside the bearing bracket.
There are a few spacer washers there.

Ride the bike to heat the bushing up so it soaks the oil in.

The MaxTorque clutch has an oilite bushing only on the sprocket side.
See the diagram here
http://www.maxtorque.com/html/ss_clutch.html

EZM Qmatic transmission
I was told that I should put a few drops of oil on the
Clutch bushing. I would like to know if someone would
Be kind enough to put up a photo .I would not want to
Put it in the wrong place. And mess up perfectly good clutch.
.
 
Last edited:

azbill

Active Member
May 18, 2008
3,358
5
38
63
Fountain Hills, Arizona
attached is a blow-up picture of the Max-Torque six shoe clutch,,,
part #3 is where you need to oil

you want to run the bike for a bit to get the bushing hot enough to weep the oil into it
(make sure the engine is off so the oil doesn't get all over the clutch shoes/bell,,,ask me how I learned that !!!)
 

Attachments