cvt,any good?
- Thread starter robdog
- Start date
I have had good service from mine:
http://motorbicycling.com/showthread.php?t=57161
Some people say they got one with a "bent shaft" - actually the only thing wrong is the outboard pulley is not installed properly. I think the chinese guy that assembles them only has one eye. Mine had 6 rollers in it, some only have 4. You wind up with 3 in it anyway if you want better acceleration...
Bike has been a solid ride. 27 to 30 mph, lots of WOT. Starts on the first pull warm.
.
http://motorbicycling.com/showthread.php?t=57161
Some people say they got one with a "bent shaft" - actually the only thing wrong is the outboard pulley is not installed properly. I think the chinese guy that assembles them only has one eye. Mine had 6 rollers in it, some only have 4. You wind up with 3 in it anyway if you want better acceleration...
Bike has been a solid ride. 27 to 30 mph, lots of WOT. Starts on the first pull warm.
.
well thats good to hear.I still have a chain drive thats hangin on but not for long .Thanks for your info ffv8.
Just seen this: i have one and did not use it yet as the shaft threads are corked,were the clutch bell screws on.I am going to turn a new shaft and rethread it straight,when the time comes to use it. I got mine form scooterparts4less.com ,but that was a half doz.years ago..........Curt
FFV8 were did you get yours from?
FFV8 were did you get yours from?
I bought one about a year ago but hadn't used it yet either. I was thinking about using a jack shaft to run it and mounting it behind the seat post tube but changed my mind until I find a bigger frame to try it on...
was also thinking about taking it apart and putting better bearings on both shafts before trying to use it.
was also thinking about taking it apart and putting better bearings on both shafts before trying to use it.
