Re: Wheel problems V4
-Hey Cylon, Those molded aluim wheels work well as they have sealed bearings and are super strong and true However... They are not cheap either. I am trying to use them now and bought a 6 hole 44 t sprocket that was supposed to fit that hub side and it does bolt on directly but not really well as the hole is too small in the center and leaves a gap that will shear the sprocket off in time...ughhhh. So now I have to machine out the center hole on the sprocket, so it fits over the raised ring on the hub side. But I am worried about chain alignment when I finish the build. The hub adapters are nice as you have a 1/2" fore and aft adjustment for perfect chain alignment. It never ends with wheels sometimes.
-Another option for HD wheels is to buy a Huffy Cranbrook for 88.00 bucks from wally world just to get the wheels as they have heavy duty 12g spokes and steel rims. They use a 1.5 hub so you would need a new hub adapter as they sell them separately. The 1.5" hubs give more surface area to grip the hub also. I've never had slippage or a broken spoke... ever on huffy wheels using a hub adapter.
-I am in the early stage of building a welded tank Board tracker now and I ordered a girls Huffy bike with the correct color wheels I needed once again. I just to take the good wheels off it. Then I sell the frame for 60.00 to a local guy and the HD wheel set costs me only 28.00 bucks! Way cheaper than buying just wheels, makes no sense. Me likes 12 gauge spokes!
-you could also fix the broken spokes and use coke can shims to get more grip and take a center punch and hammer in a ton of dimples in the hub adapter surface to rough up the surface a bit for better grip. Its also possible your hub adapter bolts are bottoming out and not tightening all the way. I remember I had this problem on a cheaper knock off adapter, remove a 1/8" off the two hub adapter bolts?
"One pull and It's on, one snip and its off"
“Lets not get too technical”
Last edited by ZipTie; 10-20-2016 at 01:23 PM.