Motorized Bicycle Engine Kit Forum  


Go Back   Motorized Bicycle Engine Kit Forum > Bicycle Engine Kit Repair - Top Posts > Instructions for Building and Repairing Motorized Bicycle Engine Kits

Instructions for Building and Repairing Motorized Bicycle Engine Kits Classic posts on building, repairing and modifications.

Thread Tools Display Modes
Old 01-11-2009, 08:11 AM
Bikeguy Joe Bikeguy Joe is offline
Godfather of Motorized Bicycles
Join Date: Jan 2008
Location: up north now
Posts: 11,531
Default Thought and Observations....Chain and sprockets

Here are a few thoughts I had, wanted to share them especially for/with the newbs.

Although it isn't crucial that the chain be in perfect alignment, it helps with smoothness, wear and the chain staying on.

Having the rear sprocket centered and mounted so it doesn't wobble side to side is also not absolutely crucial, but helps A LOT with noise, smoothness and longevity of the chain/tensioner and sprockets.

Finally, and I write this because I see a lot of it- do not over tension your chain!

Not only will it increase wear and noise AND vibration, it also causes a lot of un needed problems with the stock tensioner.

Finally, over tightening the chain will cause rapid wear to the rear wheel bearings and the countershaft sprocket bearings (clutch shaft bearings).

You may not notice it right away, but it's happening.

3/4" of freeplay is about right.

Thanks for listening,

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 08:36 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2017, vBulletin Solutions, Inc.