diffrent carby would be nice

GoldenMotor.com
F

fast70cc

New Member
May 8, 2011
3
0
0
morayfield
these carby are **** ive raped mine and im over itt and i need to find cluch parts anyone know where the bit im after is the peace at the end of ya cluch cable the big (L) lice that slides into the motor then touches the sprooket on thhe inside of ya motor
 
Last edited:
S

scooter325

New Member
Jan 27, 2011
5
0
0
st.petersburg fl.
To adb140275.What site can I get a 14mm dellorto set up for my GT5 RAT MOTOR?Isure would apreciate the info.Ive got the cns v2 and I am not happy with it.I had the cns v1 on my last bike and that worked much better.I was gonna get another one of them but if you could direct me to a Dellorto that would be way cool. keep the rubber side down. Scooter325
 
L

Lubo25

New Member
Dec 22, 2009
10
0
0
hamilton
always check your float level, needle sizing, depth setting, and of course make sure everything is sealed tighter than fort knox, these tips make garbage carburetors better

try some ultra black around the float bowl and around your intake piping

dual jetting is what you need though for higher fuel efficiency with better power broadening
 
You must log in or register to reply here.
Top Bottom