Hi, I'm from Romania , and for my project , motor bike , I need a diagram of the electronic ignition from McCulloch pm 610. Any information is welcome.
electronic ignition from McCulloch pm 610
- Thread starter zaharias
- Start date
Also mention that there are no ignition in Romania ( Europe ) , nor the USA can not buy, we are after another planet ...
i found a catologue diagram, probably not what you need though
I also found this forum, not sure if they are any good, but they have a dedicated section for chainsaws, you may have better luck asking this question there.
http://www.forestryforum.com/board/...ml?PHPSESSID=c5c6e81a0f5bbab64a6f9f6e6cb7ab33
good luck!
I also found this forum, not sure if they are any good, but they have a dedicated section for chainsaws, you may have better luck asking this question there.
http://www.forestryforum.com/board/...ml?PHPSESSID=c5c6e81a0f5bbab64a6f9f6e6cb7ab33
good luck!
If the timing is close to 20 thousands gap liken to contact points. In my experaince a aftermarket electronic ignition from most any motor can cross over. 20 tho gap is pretty common across a few makes of small engines. Just a thought for you any way. Hope that could possibly help?
