My new project

I turned the on/off switch on and it lit up.
I twisted the throttle but motor does not spin ?
Help?

motor- red and black wires - where to connect?
controller- red and black wires - where to connect?
left over wires: 1 large red and 1 small red wire from fuse - where to connect?

Note: red and black on motor does not connect to red and black on controller,cause itryed that already.

The sewing machine foot peddal works, but when pressed i get full speed and power.
I guess thats ok,its not like it will go too fast or anything. Im using a 30amp fuse and the wires look ok. I can hook the battery charger socket wires right to the battery wires for charging.

Is a controller just for so you can use a throttle and control your speed?

Tommorrow's test is a test right in my back parking lot,wish me luck.
If it goes to fast maybe i can connect it so i would have a choice of 12v or 24v so i would have 2 speeds.

*I will be posting in the DIY homemade thread section*