I am thinking of doing a Predator 99cc pusher but would like to do a manual clutch. How do I either do it or where do I buy one???
Easiest thing would be to set up a jackshaft primary drive and use a pully on the engine instead of a centrifugal clutch, and fab a spring loaded idler to press the outside of the slack side of the belt, with a cable and clutch lever to control the idler to disengage the belt. Instead of jackshaft, some have used a bike rim attached to the rear rim for a pully to get a useable ratio, and modded the frame for it.I am thinking of doing a Predator 99cc pusher but would like to do a manual clutch. How do I either do it or where do I buy one???
Similar to a motorcycle clutch. Just not anywhere near as complicated.How do they do it on a china lady?
Melted pop cans and witchcraftHow do they do it on a china lady?
Well that can be done. I have pop cans I can melt and as far as the witchcraft goes I have an ex-wife so that probably has that covered... Thanks Charlie!Melted pop cans and witchcraft