Hi ,so I've been on here for a few weeks and after the advice that I got from some one on here ,thanks again by the way !! I have learned the answers to most of my questions !!! I have some new questions and I did look for them and couldn't find a strait answer so here goes ,1 How dose the clutch base separate from the clutch bevel wheel gear thingy ??The clutch bearings feel bad and it's hard to turn also !! 2 question The mandrel that holds the shaft fixed pin in ,that pin is bent bad ,so bad that it had oval-ed out the holes that it sits in the ferrule ,my questions is that pin is it sacrificial and if so can I make it out of a nail or do I have to spend 2 bucks and shipping for a new one ???? And the 3 would be the ferrule that the pin sits in can I turn it 180 and just drill new holes in it or will I have to spend the 3 bucks on that !! Either way I have to place an order to get new pads !!!O ya when I took that screw out of the front small gear that star washer was not there !!! And I want to say there is a but load of answers on here just have to take the time and read everything !! I'm am so happy that I had found this site !!Thanks for any help man !!!