Bike to Trike Conversion Question

GoldenMotor.com
2

2dawgs

New Member
Feb 15, 2010
209
0
0
Gilbert, AZ
I ready the order the trike conversion bolt on and want to install a rear mounted 4 stroke engine.

I looking for some guidance on how to install a drive sprocket on the trike axle to hook up the 4 stroke.

Are there any bolt on drive sprockets that fit the trike axle?
 
A

AzToker

New Member
Feb 28, 2010
78
1
0
Too Stoned, Az
My old trike had the welded on sprocket to the hub. That didn't last long. I end up ordering a new rear hub with 2 sprocket on it and adding mm adapter to it. That was for the 2 stroke set up. Should work just fine for the 4 stroke set up. Make sure you get the hub with the 2 sprocket closer to the pedal side as you really dont have much room on the hub. I am building up chopper trike with 4 stroke kit. Good luck!
 
fatdaddy

fatdaddy

New Member
May 4, 2011
1,516
4
0
San Jose, Ca.
I hope I'm not too late to help with some advice. I just signed up to this site yesterday. Anyway, Check out Staton Inc. I think they will have what you need.
Thanks,
Fatdaddyred.
 
You must log in or register to reply here.
Top Bottom