So my exhaust was getting in the way of my right peddle. I clamped it on the table and then bent it. Now it clears it by a good 2 inches, however; I seem to have bent it outwards so that the exhaust is almost perpendicular to the ground. Are there any possible problems that could occur from the exhaust not facing backwards?
Direction of the Exhaust/Muffler
- Thread starter tmcgradyr01
- Start date
I haz stinky shoes - but it's nuthin' to do w/me bike o.o
Well, it's hard to tell without pics but while the exhaust shouldn't have a problem getting out, you might have a vibration problem and possible fastener failure eventually if yer pipe is just stickin' out unsupported.
I don't think it's a big problem or anythin' - I've just never been a fan of the stock pipe design. Depending on how far it sticks out you may want to rebend it and/or add a support bracket if you're able.
*goes to change socks*
Well, it's hard to tell without pics but while the exhaust shouldn't have a problem getting out, you might have a vibration problem and possible fastener failure eventually if yer pipe is just stickin' out unsupported.
I don't think it's a big problem or anythin' - I've just never been a fan of the stock pipe design. Depending on how far it sticks out you may want to rebend it and/or add a support bracket if you're able.
*goes to change socks*
A propane torch will heat it enough to make it easier to shape but you'll probably have to paint the header section when your done.
