bearing question

GoldenMotor.com
fakeplay

fakeplay

New Member
Jul 26, 2009
67
0
0
newburyport ma
I'm talking about the ten t sprocket on the motor. If I take off the nut and washer, There should be a bearing visible right ? Is that bearin the enclosed type or is it the open type where I could put some grease on the ball bearings. This motor is noisie and I'm thinking they pressed the bearing into to tight of a hole. A bearing should have .0005 press fit but I think the hole was smaller when pressed in. Appreciate any help.
 
Norman

Norman

LORD VADER Moderator
Jan 16, 2008
2,606
7
38
71
pampa texas
fakeplay
you can put grease into the mount for the lower clutch hole by taking out the lower clutch mount hold the grease gun up to the hole tightly and give it a few shots. if you can find a Zerk to fit the hole or a rubber tip for the grease gun it will go a lot easier. Keep an eye on the clutch side as you don't want a bunch of grease getting there. The bearings have a seal on the out side if I remember right they did not have a shield on the inside on mine.
Norman
 
You must log in or register to reply here.
Top Bottom