So, working on my chainsaw(trimmer) powered bicycle and I thought I conquered the problem I had with mounting a sprocket on my engine. After some careful case trimming, I made clearance for a sprocket. Now I think...get to Ebay and order up that sprocket. Much to my chagrin, I think a 10T sprocket is too small for a 1" bore...but I need one...badly. I cannot find one anywhere. At this point, it is about the only way I can make this work. Does anyone have a secret stash of totally unsafe sprockets in their closet. Do you know where I might find one. I plan on welding it to the clutch bell, so it should maintain its integrity...somewhat...If anyone has any ideas, let me know, thanks.
I need a 10T 41 P 1" bore sprocket
- Thread starter Twisted Spokes
- Start date
10 tooth 41 sprocket has a Max ID of 3/4"
The smallest 41 in a 1" ID is 13 teeth.
You can get an 11 tooth in 7/8" ID
