Custom intake manifold

Wut........like dis?







Hey Matt, it's really nice to see your taking matters into your own hands and doing your build right with a little fabrication.......excellent

Kinda funny I saw your post this morning and happened to be making an intake mani for my current 4-stroke build today as well.

Keep up the good work.......we will ride soon!

scotto-

now thats different

I went to supply company got weld pipe fittings. I used a 90 and two 45's.

For those without a welder, you can get a 45Degree copper elbow piece, a strip of aluminum from a can or flashing for a spacer.

Cut to size your aluminum strip and wrap it around the end of your intake pipe, then fit on the copper elbow piece.
Make sure to sand or rough up and coat all mating surfaces and use lots of soldering flux.
Melt in some solder into your joints with a propane torch.

Make sure there are no burrs or solder drips inside the pipe.

And there you go!
I'd put a link of what I did but cannot find it.

Found it:
http://motorbicycling.com/showthread.php?t=24753&page=380Post #3796
What is on my bike is the old setup with a 90Deg. elbow.