Motorized Bicycle Engine Kit Forum  

Sponsors



Go Back   Motorized Bicycle Engine Kit Forum > Motorized Bicycle Mechanical Components > Intake & Exhaust

Intake & Exhaust The ins and outs - carburetors, manifolds, mufflers, expansion chambers and more to keep your engine running the way you like

Reply
 
Thread Tools Display Modes
  #241  
Old 11-13-2014, 10:15 AM
djpass7 djpass7 is offline
Motorized Bicycle Senior Member
 
Join Date: Oct 2014
Location: Chico, CA
Posts: 52
Default Re: ThatsDax rt High Performance Carburetor

Pull your carb off the intake and check the slide when you open the throttle. The flat slide should come almost all the way up exposing about all of the circular part of the carb. But still I recommend doing a plug chop to know for sure if you need a bigger or smaller jet. You can buy jets here.

http://www.sickbikeparts.com/catalog...roducts_id=116
Reply With Quote
  #242  
Old 12-26-2014, 06:03 AM
nitrofreak3 nitrofreak3 is offline
Motorized Bicycle Newbie
 
Join Date: Dec 2014
Location: Homestead
Posts: 7
Default Re: ThatsDax rt High Performance Carburetor

Not sure if this helps, but any way.. I just got my dax rt carb, and model my intake at 45* angle to clear seat post. Started with #85 jet to rich. Went down the line to the #65, lost bottom but cleared out up top.. a little lean. I left my index bit set at work so no way to measure jetting size, I twist four strands of speaker wire to compare. Not very accurate to say the least. But the jet that came in the carb from dax was spot on. A little four cycling at top until run wot for a bit, after warmed up and cleared out she don't skip a beat. And has great bottom end pull. Very happy with carb for what it is. P.s. I used my stock cable, I had to short in the 45* angle post that comes with carb about .350" then on the slide I used a 1/8 ball end debut dermal and made room for stock cable endo to sit up straight.
Reply With Quote
  #243  
Old 12-26-2014, 02:53 PM
djpass7 djpass7 is offline
Motorized Bicycle Senior Member
 
Join Date: Oct 2014
Location: Chico, CA
Posts: 52
Default Re: ThatsDax rt High Performance Carburetor

The stock jets in the rts are 70 but mine actually measured to be 71. mine happens to be spot on in jetting also. Glad its working out for you.
Reply With Quote
Reply

Tags
carb, carburetor, dax, dellorto, thatsdax

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 09:06 AM.


Sponsors

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
MotorBicycling.com