JNM Super Mount

C

chainganglowrider

New Member

Jul 28, 2008

3

0

0

Aug 1, 2009

• #1

Has anyone tried the JNM Super Mount ? I went go use one today as I needed to swap out my motor anyway, and noticed the holes are drilled too narrow in the rubber compared to the width of the studs. Anyone used one of these yet ?

Curtis

 

RedB66

Active Member

Dec 28, 2007

1,020

14

38

Sunshine State

Aug 1, 2009

• #2

Some of these engines are being drilled for for the larger frame tubes. It looks as if those mounts were made to fit the older (different) sized spacing.

 

L

lucajo16

Member

Dec 12, 2013

100

2

16

cincinnati, ohio

Jan 17, 2015

• #3

Hay if you don't need that mount and studs I'll buy it off of you easy. I have the smaller mount but my engine won't fit my frame without them. I know where to get the but if I can help a fellow motorbiker get some green then I'll help.

 

2door

Moderator

Staff member

Sep 15, 2008

16,302

175

63

Littleton, Colorado

Jan 17, 2015

• #4

Lucajo, This thread is over five years old.
Good luck. I hope you get a reply from the OP. He hasn't posted since.

Tom

 

L

lucajo16

Member

Dec 12, 2013

100

2

16

cincinnati, ohio

Jan 17, 2015

• #5

I doubt I'll get a responce but I posted my issue and I need those mounts if I can help it.

 

2door

Moderator

Staff member

Sep 15, 2008

16,302

175

63

Littleton, Colorado

Jan 17, 2015

• #6

lucajo16 said:

I doubt I'll get a responce but I posted my issue and I need those mounts if I can help it.

Click to expand...

Maybe try our 'Swap & Shop' section. Post it under WTB, 'want to buy' and see if another member can help you. Good luck.

Tom