Hi, I have a 66cc beach cruiser. Just got my new cns carburetor in the mail. Ok so attached to the carb are 3 transparent tubes. If somebody will please take a picture of how these tubes are supposed to be setup that would be amazing. If you can't take a picture then please explain it. Also, I do not have a choke cable for it. Can I just leave the choke opening as is or do I need to block it off? Thanks
How to install cns carb??
- Thread starter fischerking45
- Start date
-
- Tags
- carb carburetor cns installation
Hi. I have one also, after posting in introductions i did a search at yahoo and this is what i found.
http://www.grubeeinc.com/USA/STARFIRE SKYHAWK WEB INSTRUCTIONS.htm
down towards the bottom there is a few illustrations and says to leave disconnected and one tube is pointed down
apparently they are high performance carbs
jack
http://www.grubeeinc.com/USA/STARFIRE SKYHAWK WEB INSTRUCTIONS.htm
down towards the bottom there is a few illustrations and says to leave disconnected and one tube is pointed down
apparently they are high performance carbs
jack
I just put on my cns cone high performance carb and I can't get it to
Stop leaking from the overflow ! What could b wrong?
Do I have to have a slant mana fold?
Stop leaking from the overflow ! What could b wrong?
Do I have to have a slant mana fold?
You can't.
You have to drill out the air idle screw and that helps. After that, if you're still running lean or rich, you'll have to rejet the carb.
You have to drill out the air idle screw and that helps. After that, if you're still running lean or rich, you'll have to rejet the carb.
Do u kno anything about the black expansion chamber
exhaust, I.e, how to put it together ? Just got it and
it is all in pieces . Didn't get instuctions.
Can u help??
exhaust, I.e, how to put it together ? Just got it and
it is all in pieces . Didn't get instuctions.
Can u help??
