Im using a set of calipers of an old raleigh bike i found and ive run into some trouble. The bolt that runs through the front brake needs replacing, but at this point im not sure if a replacement exists.
It seems to be about a M7... maybe even a M6.5 (if that exists), and the thread pattern is .75 as close as I can tell. The threads are coarser than a .70, but are finer than a .80.
If its standard its about a 1/4" with a thread pattern just slightly finer than 32.
Anyone have any info on this strange fastener?
It seems to be about a M7... maybe even a M6.5 (if that exists), and the thread pattern is .75 as close as I can tell. The threads are coarser than a .70, but are finer than a .80.
If its standard its about a 1/4" with a thread pattern just slightly finer than 32.
Anyone have any info on this strange fastener?
