Hello all. I am in a dilemma of sorts. I was installing a engine on my bike and in the middle of the install, I misplaced the bolts for the plate/cover on the rear left side of the motor (because of moving to a new place). Question is, what are the measurements for these (there is three of them) so that I can get replacements?
lost cover screws
- Thread starter pedrorican43
- Start date
IGNORE THIS ADVICE, I SCREWED UP!
Try Home Depot or Lowe's
5 mm - 0.8 mm x 10 mm cap screws (you'll need a 5mm hex-key)
If you're in a bind, you can "borrow" 3 of the screws from the clutch-cover.
Try Home Depot or Lowe's
5 mm - 0.8 mm x 10 mm cap screws (you'll need a 5mm hex-key)
If you're in a bind, you can "borrow" 3 of the screws from the clutch-cover.
Last edited:
The screws are 6 mm x 1.0 and 25 mm long.
You don't need the back one longer ar 40 mm if you aren't using
ot to attach the chain guard.
