working on a new vintage bike project now--

GoldenMotor.com

weekend-fun

New Member
Jun 21, 2009
999
0
0
San Carlos CA
That is awesome! I have had alot of fun riding my bikes this summer including riding them with friends who come to visit me in my small town from all over the world. I took them to the Lead Sled National show and we were able to ride them all over the show grounds. Here is the thread on the hot rod message board "The HAMB" that poo poo pipe was talking about. My new toy--every Hamber should have one-- - THE H.A.M.B.
What engine did you use in the first pic?

also, is your frame a singlespeed? i would think you eould need to re-weld and space out the rear triangle if you wanted a whizzer sheave to fit...


sam
 

Russell

Well-Known Member
Apr 19, 2009
1,276
155
63
MA
changed the bb area,bottom of the first page
Great Looking ride. Was the shipping cost high om the large pulley?
Could you tell me where you got the j-shaft berring or did you fabricate it?

thanks
Russell
 

povertyflats

New Member
May 22, 2010
53
1
0
near Salina Kansas
If I remember right, the shipping from Taiwan was $25 and the Whizzer sheave was $29.99. It was one of those make an offer listings on Ebay. So I bought 4 of them for $25 each and still paid $25 shipping. As for the jackshaft and bearing those items can be fabricated from parts purchased at a farm supply store.
 
Last edited:

charles kohler

New Member
Sep 6, 2010
7
0
0
90
ohio
many elect wheelchairs use a vbelt pulley on there drive whells.
i have one on an elect bike built a few years back
a lot of the older chairs had a drive pulley on each wheel.most have beeb scraped.
the tinman.