Honda Gx160/200 Gearbox

BigBlue

Member

Nov 29, 2011

781

0

16

California

Feb 25, 2012

• #1

FYI,

found this seller on Ebay selling 2:1 gear reduction boxes for some Honda GX160/200 engines. I underlined "some" because it only works with specific types of engines. I would carefully read the item description to see if it would work with your application

http://www.ebay.com/itm/35048945637...X:IT&_trksid=p3984.m1438.l2649#ht_1161wt_1185

Good Luck

Chris
AKA: BigBlue

 

Last edited: Feb 25, 2012

scotto-

Custom 4-Stroke Bike Builder

Jun 3, 2010

6,505

24

38

Ridin' inSane Diego, CA.

Feb 25, 2012

• #2

Wow, almost $300 with shipping.......that's a little steep in my book. I'm not so sure that set-up would work on a motorized bike judging by where the output shaft is located?

But thanks for sharing this info.....

 

foundmydog

New Member

Oct 17, 2011

258

0

0

South Carolina, USA

Feb 25, 2012

• #3

you figure a GC160 is 11 or 12 inches wide plus another 2 to 4 inches for that gearbox would make for one very wide stance!

 

wayne z

Active Member

Dec 5, 2010

1,743

5

38

louisiana

Feb 25, 2012

• #4

foundmydog said:

you figure a GC160 is 11 or 12 inches wide plus another 2 to 4 inches for that gearbox would make for one very wide stance!

Click to expand...

And you would still need a jackshaft for ratio and chain alignment. Now if they made one with the output on the opposite side, we could prolly work with it by using a large sprocket or sheave on the wheel.

 

cannonball2

Well-Known Member

Oct 28, 2010

3,682

221

63

Colonial Coast USA.

Feb 26, 2012

• #5

Ive got one of those that was on a clone engine a friend gave me. He runs concession karts with these units. Says the boxes out last the engines. Its a pretty cool setup with the wet cent clutch, looks well built. But is BIG.