32" Genesis Super Cruiser (Help)

GoldenMotor.com

joker

New Member
Oct 6, 2009
78
2
0
clearwater
A buddy of mine just bought a super 32 and just got his new motor kit
no matter how you squeeze it a china girl will NOT .shft.fit.
it's kinda like oj's glove if it won't fit you must quit. our solution is to
cut the bar flip it upside down and weld it back in place, another delima
is that the front bar where the motor mounts to is way to wide so you
would have to notch it and reweld it. then you need to repaint it, but if
thats not enough try to find tires and tubes first nothing worse than commiting
to the hours of fabrication get it done only to find out the tires are 100.00
each if you can find them.

ride on JOKER
 

Master-shake

New Member
Feb 24, 2013
315
0
0
texas
Man that onyx is already hard enough to deal with, why would anyone bother with this one. Money pit if I do say so myself.
 

riden60

New Member
Oct 11, 2014
1
0
0
Fresno - Madera CA
So my Motorized 32's rear wheel bearings went out and yes I grease them regularly. I think it was my fault though, I don't think I had put the hub back together correctly when I first got it and damaged them. They just gave out now... any suggestion?
 

lowracer

New Member
Oct 17, 2008
1,319
2
0
Charleston, SC
That bike would be a good candidate for a DIY top tube mounted shift kit. A little angle aluminum, some clamps, a 5:1 pocketbike transmission, longer bottom bracket, front freewheel and good to go. Those big wheels will roll!
Or can do a front wheel mount and drive, or rear rack.
Cheers,
-Low-