On my ryobi 31cc I took the flywheel off to access the stronger mounting holes on the engine. When I put it back on it wont start now. I also took off the cylinder and cleaned it.
I made sure the gap was right and it has spark, I also made sure that everything is there and is working properly.
It just wont start, I think I got it to fire but just wont run.
Any advice would help.
I made sure the gap was right and it has spark, I also made sure that everything is there and is working properly.
It just wont start, I think I got it to fire but just wont run.
Any advice would help.
