Primary side crankshaft gear

GoldenMotor.com

shearbf

New Member
May 8, 2009
77
0
0
Muskegon,MI USA
How is the primary gear removed from the right side crankshaft end? HELP! No puller available to fit inside caseing along the sides of the gear.
I am installing a centrifigel clutch and STUCK here.
Any quick help absolutly apreciated.

"Good judgement comes from experance. Experance comes from bad judgement."
 

Aaron Parks

New Member
Mar 29, 2010
18
0
0
Potterville, MI
There's a gear puller available that will thread into the gear so you don't have to grab it from the sides. I think I bought mine from Spooky Tooth. They have it in a kit with the spark plug wrench. Here's a picture of it being used to remove the sprocket on the left side.

 

shearbf

New Member
May 8, 2009
77
0
0
Muskegon,MI USA
I have this puller. I thought it was just for the clutch shaft gear as shown in the pic. I
Didn't even think to try it on the other side primary gear yesterday.
Over and over, I am so impressed with the design enginering of these wonderful, simple little motors.