I just installed a manic mechanic billet intake. the carb fits with the attachment but the carb has to tilt slightly. It hits on the clutch spring holder, not the clutch lever but where the small spring starts. I was wondering if the carb is ok running at that tilted angle or could i lower that clutch piece to level the carb?
Unscrew the clutch cable holder and cut off the bolt to lower it as much as possible.
You can cut about 1/4" off.
Then it will clear the float bowl so it isn't tipped sideways.
The straight inlet is supposed to come with that instruction.
You can also get rid of the spring like 2door said so your clutch pull will be easier.
What NT carb are you buying?