need help with throttle

GoldenMotor.com
M

masterx1234

New Member
May 7, 2009
51
0
0
grayson Kentucky
ok i got the throttle hooked up but heres the problem, theres too much cable, the throttle does
not return to the normal position, and the cable slacks, what do i do?
 
R

radrob

New Member
May 2, 2009
98
0
0
Tacoma Washington
the plunger in the carb is probably getting stuck. unscrew the cable, spring,plunger assembly. make sure the slit in the plunger lines up with the notch in the carb and slides all the way down. I dont think the plunger is sliding all the way down.
although i am still new to this.
i had what i belive is the same problum as you are having

rob
 
Bikeguy Joe

Bikeguy Joe

Godfather of Motorized Bicycles
Jan 8, 2008
11,837
252
63
up north now
That sounds like good advice....sometimes, the slide (plunger) will fit too tightly and not want to slide very well. You have the spring in there, right?
 
M

masterx1234

New Member
May 7, 2009
51
0
0
grayson Kentucky
i got it fixed!, i found a way to make it work without cutting or bending the cable, i took a peice off my old bike and fitted it on the cable so it doesnt slack and now its going good
 
You must log in or register to reply here.
Top Bottom