How to take the clutch apart?

GoldenMotor.com
B

Black_Moons

New Member
Oct 25, 2010
205
2
0
Canada, Bc
Hi, I recently pulled the clutch off my motor and im wondering, How do I get it apart? IE remove part 3-13 from part 3-6 so that 3-9 comes free? (Part that holds the ball bearings and spiral gear to the rear clutch plate)

I know this is gonna send tiny bearings everywhere.. but I still want in there.
 
Creative Engineering

Creative Engineering

New Member
Sep 20, 2008
1,668
12
0
Clearwater, FL
web.tampabay.rr.com
Black_Moons said:
Hi, I recently pulled the clutch off my motor and im wondering, How do I get it apart? IE remove part 3-13 from part 3-6 so that 3-9 comes free? (Part that holds the ball bearings and spiral gear to the rear clutch plate)

I know this is gonna send tiny bearings everywhere.. but I still want in there.
Click to expand...
Look at animation #2

http://motorbicycling.com/f30/animated-view-motorized-bicycle-clutch-assembly-8939.html

The ring with the ball bearings is a press fit onto the shaft. To get them apart, I hold the gear and tap the three pins evenly with a brass hammer.

Jim
 
B

Black_Moons

New Member
Oct 25, 2010
205
2
0
Canada, Bc
Hmm, Hold the gear with a bored peice of wood or something?

I was afraid that might snap the gear where the pads are held.

So the 3 small 1/8" or so holes on the backside do not go through?
 
You must log in or register to reply here.
Top Bottom