Do you guys have any tips/ tricks for drilling a hole in the handlebars??? My last build was halfway finished when I got it so I didn't have to worry about it before, but now it has come back to haunt me. Any help is appreciated
Just curious. Why do you say that?DON'T!
Are you talking about securing the twist grip?
never drilled and never had any problems with it loose-
Did I knock off some little plastic part on it long ago? Are they still on there like that?
It's overkill-
I put an old exhaust stud through mine. works good.Whenever I used the cheap plastic throttle, I'd drill a small hole in the bars where the nub would go......then drill through the plastic housing of the throttle (where the alignment nub is) and drive a sheet metal screw through the housing into the hole in the bars. Done deal....throttle stays put.
Did I mention that I ride at WOT alot? Thus the reason for securing the cheapo plastic junk throttle.