I have had my motor apart several times without replacing the rings and so far no problems.if i remove the piston from the cylinder in order to clean up the ports will i have to get new rings even though the engine hasnt been run? anyone done it before without rings failing right afterwards?
also. im realizing it might be a while before i actually have the engine running are there any problems i could look for to be sure this is a good engine not in need of returning while it sets on the shelf waiting on me to order hubs for the bike?
What was the part number you ordered? Was it the same on your invoice?had ordered rims and spokes from husky. they got here today the rims were supposed to be 26x2.125" wide but they are more like 1.5"! now i know 26" means the outside of the tire on bicycle rims not the actual rim measurement but this doesnt seem correct am i missing something or they sent me the wrong thing? i ordered 11g spokes and the look pretty tuff compared to whats on my mountainbike(14g) but they dont look excessive like i had imagined anybody have any experience with this stuff