ughhhhh
- Thread starter ct66rider
- Start date
I bought an easy out small enough for that at OSH for 4 bucks. An alternative that might work is to cut a slot in it with a dremel cut off bit and use a small flat head screw driver. The only problem with that is when you cut the slot you will end up cutting some of the engine case also depending on how tight the stud is in there you might not be able to get enough torque on the stud to get it out that way.
I have used a jewelers file and cut 2 slots inside the hole, then get the same size screwdriver and back it out. It worked for me.
Jim
the dremel trick worked for me, but what i did to minimize the case cutting was to use a cutoff disc that was worn down in diameter so it wouldent cut the much of the case, good luck 
