View Single Post
Old 08-14-2009, 11:02 AM
lordoflightaz's Avatar
lordoflightaz lordoflightaz is offline
Motorized Bicycle Elite Member
Join Date: Jan 2009
Location: Phoenix, AZ
Posts: 296
Default Re: Kill Switch Mounting

You probably can knock out the pin and not drill the hole, but then you would need to make sure that the throttle assembly does not spin on the handlebar. Grip shifters have a tightening ring built in that do that, these throttles don't have that.

I would drill the hole. You should be able to drill the hole without putting it in a vise. Just mark it, center punch, drill it with a 1/8" bit then use the proper bit to widen the hole.
Map your motorized bikes location on a Frappr Map show us where you are and post a pic of your bike.

If trailer parks didn't exist would tornadoes exist?
Reply With Quote