View Single Post
Old 08-14-2009, 08:43 AM
pedal pusher pedal pusher is offline
Motorized Bicycle Senior Member
Join Date: Feb 2009
Location: Charlotte, NC
Posts: 54
Default Kill Switch Mounting

I am a first time builder struggling along with the GasBike 66/80 kit. The minimal instructions say to "drill a small hole in the handlebar for the pin on the kill switch." Looking on the Zone 8 instructions it says to drill a 5mm hole 125 mm from the end of the handlebar. I guess the best way to do this is to put the handlebar in a vise and dimple it with a punch, then drill the hole. Or, can you cheat on this and not do any of it, just screw it on?
Suggestions greatly appreciated.
John, aks Pedal Pusher (not riding, just pedaling)
Reply With Quote