View Single Post
Old 08-13-2009, 08:49 AM
mxchris727 mxchris727 is offline
Motorized Bicycle Member
Join Date: Aug 2009
Location: Wilton, CT
Posts: 34
Default Re: Engine Block Problem (Mounting Studs Are Broken)

That's what I did, I started with a small size bit then continued to go bigger. Eventually I was at a perfect size and was able to screw the studs in tightly. BUT.... After I did this, I realized that I had drilled too far and now there is a hole in the cylinder! I don't think I could epoxy it because there is too much pressure in the block.

I will try to upload pictures soon...
Reply With Quote