Thread: #41 chain
View Single Post
Old 08-10-2009, 09:28 PM
am21 am21 is offline
Motorized Bicycle Newbie
Join Date: Jul 2009
Location: Texas
Posts: 3
Default Re: #41 chain

thanks for all the replies, i didnt have an extra sproket laying around so wat i ended up doing was taking some metal strips that had holes for nuts to go through as my base anad i tried using a hammer and a nail but after abut 15 min and hardly any succes i went back to the dremel and made the pin flush and tryed my chain tool again and after a couple of trys of turning the screw on the tool as hard as i possibly could i finally got it =), the #41 chain runs so much better then the orginal, i wish i had put it on to begin with
Reply With Quote