View Single Post
Old 07-25-2009, 08:16 PM
Maxvision's Avatar
Maxvision Maxvision is offline
Motorized Bicycle Elite Member
Join Date: Jun 2009
Location: San Diego, CA
Posts: 551
Default Re: Won't idle with clutch in, help

Didja try tightening up your clutch cable?

Perhaps the set screw on the end of your cable wasnt tightened enough and the cable was slowly pulling out. I know on my engine I have to pull that clutch cable REAL tight before you tighten the set screw on the end of the cable and make sure the set screw is REAL tight too. The stock clutch lever on the handle bars barely have enough travel in them to fully disengage the clutch.

Last edited by Maxvision; 07-25-2009 at 08:22 PM.
Reply With Quote