View Single Post
Old 05-07-2009, 11:40 PM
2door's Avatar
2door 2door is offline
Super Moderator
Join Date: Sep 2008
Location: Littleton, Colorado
Posts: 16,221
Default Re: idle srew question

Originally Posted by masterx1234 View Post
ok thanks for the reply, i am so new to this and im really nervous about my bike, i rode it earlier (9:00 PM) and it went full blast on me, then i knew what i did wrong, i forgot to put the u shaped flat piece inside the end that went into the carberator, the needle wasnt being pushed down by the spring so the bike went so fast i just hit the kill switch (thank god it worked), and also, i have one of the kill switch wires wired to the nut that holds the muffler on, is this ok?
You didn't say where the other wire from your kill switch is going but apparently it is on the blue wire from the engine if it works. Below is a diagram showing the prefered way to wire the ignition/kill switch.
Glad you were not injured and figured out the throttle problem. Have fun and ride careful.
Attached Images
File Type: jpg Electrical Diagram.jpg (48.5 KB, 40 views)
Age and Treachery Will Always Triumph
Over Youth and Skill & "Charlie Don't Ride"

Last edited by 2door; 05-08-2009 at 09:41 AM.
Reply With Quote