View Single Post
Old 04-26-2009, 07:54 PM
Rockenstein Rockenstein is offline
Motorized Bicycle Elite Member
Join Date: Feb 2009
Location: Ontario, Canada
Posts: 442
Question Centrifugal clutch kit cover clearance

Just out of curiosity for those that have installed a centrifugal clutch kit after grinding the pins flush did you encounter any problems with the cover not clearing the clutch plate? I'm not clearing the clutch plate by a few millimeters even with the 2mm gasket that I just made...I could make another I suppose but stacking gaskets is kind of a hack way to do things IMO.

Maybe I could thin out the clutch pads or clutch plate a little?

Things are never as easy as they seem are they when we deal with these fine made in China

Reply With Quote