View Single Post
Old 04-13-2009, 11:33 AM
commander's Avatar
commander commander is offline
Motorized Bicycle Elite Member
Join Date: Mar 2009
Location: penn state
Posts: 205
Default Re: So many problems, Just wanna know....?

Yea Toy I was gonna suggest that also, if you attempt to weld to the engine block itself I can guarantee a failure will happen. Part of it just cast aluminum, it can be welded best using a tig welder but will not hold under much pressure.

Your best bet is to make a steel brace to bolt to the motor mount itself and then fit your brace to your bike. I have used the "drill your frame and use 1 bolt " method but it broke after just 1 mile, so i made a wider steel bracket and used a u-bolt to tie into it and that u-bolt wrapped around my lower center post like on most motor mounts.

good luck
For when it is to rainy and cold outside to play with my bike .
I go here
Reply With Quote