View Single Post
Old 03-08-2009, 11:11 PM
Josh380 Josh380 is offline
Motorized Bicycle Senior Member
Join Date: Feb 2009
Location: Aliso Viejo, CA
Posts: 52
Default Re: Motor running faithfully now, but.......

Originally Posted by MB-Monkey View Post
I second the motion My last bike did the same thing until i moved the clip and and then it ran really nice also make sure you gAp the plug properly the NGK plug in my exp was a much smoother burn
You're both right. I moved the clip up one, what a difference! I put in the NGK plug, got an accel 8mm plug wire that has RF shielding (no more speedo resetting), and noticed an immediate difference in the way it ran. It ran a lot smoother, way less vibration, throttle was very responsive, a lot quieter, and I topped out at 28 mph on flat ground. Now if only I could figure out where the rear wheel is rubbing....may need to have it trued since it's new. Should I take off the rear spocket before I bring it in?

What gap would you suggest MB?
I live in a constant state of organized chaos

Last edited by Josh380; 03-08-2009 at 11:30 PM.
Reply With Quote