View Single Post
Old 07-03-2016, 01:53 PM
BlueSmoker BlueSmoker is offline
Motorized Bicycle Member
Join Date: May 2016
Location: Finland
Posts: 31
Default Re: Bad clutch bearing

Originally Posted by crassius View Post
nope, there is a stop ring in the hub to prevent it from being pressed too far, but I'd guess yours wasn't pressed far enough by factory

Only thing to look out for is fine, steel wires sticking out of clutch pads that can get into bearing and lock it up (trim with scissors every so often if you see them, or replace the pads).
Okay, so what is the best way to press the bearing after i have put the balls in it?
Reply With Quote