View Single Post
Old 05-23-2016, 06:12 PM
scratchbuilder's Avatar
scratchbuilder scratchbuilder is offline
Motorized Bicycle Elite Member
Join Date: Jan 2015
Location: ca.
Posts: 346
Default Re: rear suspension #2

Well back at it..cut off the old mm plate out and got a new one going..1 1/2 lower and 2" longer. Now, i can get my pz19 fitted. Because the old mm had the engine shaft 2" above the js at a 30 pull up it would bounce up and down on take off, combined with a little clutch was wild. Now i can keep the same tank and mount.
Attached Images
File Type: jpg 20160523_154236_1464043866356_1.JPG (171.5 KB, 18 views)
File Type: jpg 20160523_154315_1464043856593_1.JPG (152.1 KB, 19 views)
Reply With Quote