View Single Post
Old 04-01-2016, 07:54 AM
curtisfox curtisfox is offline
Motorized Bicycle Elite Member
Join Date: Dec 2008
Location: minesota
Posts: 3,529
Default Re: Rusty Shackleford

The guy was very knowledgeable and told me to use a piece of 1-1/4" black iron pipe from Lowe's. Weld in some washers to prevent the bearings from going in too far. Then use 5/8" shaft and put the sprockets on.
That's good to know that the bearings fit in that pipe, could cut some rings off it and make bearing mounts.........LOL..........Curt
Reply With Quote