View Single Post
Old 02-12-2016, 09:48 PM
scratchbuilder's Avatar
scratchbuilder scratchbuilder is offline
Motorized Bicycle Elite Member
Join Date: Jan 2015
Location: ca.
Posts: 343
Default Re: Here I go again,Briggs build

My bad, this pic is on my everyday rider, Del Rio'. The cc is on this thread. This set up work great. My engine pully is 1 1/2. I found one that is steel and 1 5/8..made a difference that is good. I tried 1 3/4, and that was too much. I've been using pot metal pulleys and the V gets worn wider. No more swap cooler pulleys!
Reply With Quote