View Single Post
Old 09-24-2015, 01:02 AM
Davezilla's Avatar
Davezilla Davezilla is offline
Motorized Bicycle Elite Member
Join Date: Mar 2014
Location: San Antonio Texas
Posts: 2,710
Default Re: HI All, two not so simple questions.

For the cylinders... definitely the right seller... these are the best quality cylinders I've seen so far, not only with the ports but just the total build quality. Fins are cast nice and thick, plating inside looks great with very minimal overhang in the ports, and of course, huge ports on all of them.
When I see stuff like this I usually buy as many as I plan on using then pass the word on in the forum so I bought 6 of them last month that either have been or will be installed on Dax bottom ends.
So far I haven't seen enough significant difference in pistons to say one vendor has some really good ones compared to the others. One thing I would really like to see is a set of rings that could be gapped by the end user as these rings have huge gaps that are too wide from the factory. If these gaps were tighter they could be set by the end user with a jeweler's file for better compression due to less blow by.
Reply With Quote