View Single Post
Old 09-10-2015, 08:07 PM
Tony01's Avatar
Tony01 Tony01 is offline
Motorized Bicycle Elite Member
Join Date: Nov 2012
Location: San Jose, CA
Posts: 606
Default Re: what did you do to your motorized bicycle today?

Finished cutting and grinding/shaping my 2-speed jackshaft plates. I was cutting and grinding these for about four days. Each plate is 3/16" iron and weighs a bit over a pound. Once I get the setup solid and it comes time to paint, I will remove the plates and drill around 40 holes to remove a pound!!

The big issue right now is chainline and deciding if the final drive sprocket will be between bearings or not. I drew the assembly in solidworks before starting and planned on not between, but now in putting it together I can see there is more space than anticipated.
Attached Images
File Type: jpg image.jpg (590.9 KB, 44 views)
I don't always listen to Alice in Chains..... but when I do, SO DO THE NEIGHBORS
212cc 2-speed
Reply With Quote